Assembly instructions

 

When working on the rebounder legs, always do so in a comfortable manner so as not to strain you. Work with the rebounder on the side and with the leg directly in front of you.

 

Bellicon/QiBounding declines any responsibility if you hurt yourself by unpacking, assembling or dissembling your Bellicon rebounder.

 

 

Assembly for Bellicon rebounders equipped with screwing legs:

 

You should find in the box:

a)   The Rebounder frame with mat and bungee bands attached to it.

b)   A small box with 6 rebounder legs.

c)   A small plastic bag with 6 rubber tips.

 

Remove the box with the legs from its attachment to the frame (you can throw away the two bungee bands with which the box has been fixed to the rebounder frame) and open the box.

Also open the small plastic bag with the rubber tips and place the rubber tips on the closed end of each leg.

 

Remove the safety plastic caps which are placed over each of the six threaded posts on the rebounder frame and carefully screw on all six legs. Be careful to thread them on gently before screwing tight.

 

 

Assembly for Bellicon rebounders equipped with folding legs:

 

You should find in the box:

a)    The Rebounder frame with mat and bungee bands attached to it.

b)    A small box with 6 rebounder legs.

c)    A small plastic bag with 6 rubber tips.

 

Remove the safety plastic cap which is placed over each of the six leg posts on the rebounder

by pulling the leg down towards the center of the rebounder and lift off the cap.

 

When unfolding the legs, be careful not to pinch yourself with the leg. Hold the frame away from the post with one hand and lift the leg up and out with the other hand.

 

When folding the legs, be careful not to pinch yourself with the leg. Hold the frame and leg in the same manner as when unfolding. Pull the leg out towards yourself and lower it.